包米勒驱动器报2740错误代码维修

2740No polynomial curve data available
没有可用的多项式曲线数据.
It was tried to release the drive in the operation mode "Coupled
mode" but there is no polynomial curve data in the controller.
尝试在“耦合"操作模式下释放驱动器模式"，但控制器中没有多项式曲线数据。

m Consequence:
The operation in the coupled mode isn't possible. Behavior accordant to set error reaction.
在耦合模式下操作是不可能的。根据设置错误反应的行为。

2006Overvoltage in mains电源中的过电压。
The active mains rectifier unit has measured a voltage of over 530 V
effective in the mains.
有源电源整流器单元测量到的电压超过530 V在电源中有效。

Possible causes: 可能的原因：
The mains voltage has risen to over 530 V or the measurement
switch for the mains voltage measurement is defective.
电源电压已升至530 V以上或测量值电源电压测量开关有故障。